Please Note:

Wizards New Hot Tub & Outdoor Living Showroom is now open!

Need help with a hot tub repair? Need help?

FREE Delivery

Free DPD Delivery For Orders Over £60

Nationwide Delivery

Delivery right to your door

Pay Later

Spread the cost with Klarna

Sale!

Balboa GS500Z PCB Board

Original price was: £340.18.Current price is: £319.00.

In stock


Meet the Balboa GS500Z PCB

This PCB is used as a replacement for an existing GS500Z or GS500 control box with a PCB failure.

  • Manufacturers part number:54510-01
  • Length: 280 mm   Height: 130 mm
  • Commonly used with:GS500Z and GS500 control box. Topside controls from the duplex VL range such as the VL404 and the MVP260 but is more commonly used with the Mini Panel VL200. Used with QCA Spas and Splash Spas amongst others.

We are Proud to be 1 of the UK’s official distributors of Balboa hot tub parts.

Share this product

Balboa GS500Z PCB

This PCB is used as a replacement for an existing GS500Z or GS500 control box with a PCB failure. This must not be fitted to any other device/product. This should be done by an experienced tradesman or a competent individual as a faulty install could result in board damage and invalidate the warranty.

  • Power: Volts: 230 Hz:50
  • Pump 1:Single or dual speed + circulation pump if required
  • Air Blower:No
  • Heater: Yes
  • Ozone: Yes
  • Light: 12 volt
  • Sensor style: M7 x 2
  • Pressure Switch: No
  • Dimensions: Length: 280 mm Height: 130 mm
  • Compatible with: GS500Z and GS500 control box. Topside controls from the duplex VL range such as the VL404 and the MVP260 but is more commonly used with the Mini Panel VL200. Used with QCA Spas and Splash Spas amongst others.

 

Please note: All boards say GS500 or GS500Z as in the bottom left hand corner. This is just standard print. Please check the label on the software chip as this will give you the correct information on the board that you need.  If your system has an air blower or operates more than one large pump then you are likely to need an alternative board from the range.

IMPORTANT INFORMATION:
Circuit boards and other computerised equipment are exempt from our returns policy if they have been opened or installed.
If the board is suspected as being faulty, it will need to be returned to us within the warranty period and will then be forwarded to the manufacturer for inspection. If deemed to be faulty, we will replace under warranty. If the board is not at fault or is found to have been damaged due to installation, an additional charge will be required to cover the costs of shipping and return.

This unit must be fitted by a competent individual or tradesman. Incorrect installation could invalidate the warranty.

 

Scroll for more information